mugi
Posts: 1
Joined: Wed Nov 11, 2015 1:51 pm

bandicut only outputs watemark on already trimmed files

Wed Nov 11, 2015 2:32 pm

any files sent through bandicut 2.01 twice come out as nothing but a 6~42 sec long water mark

to elaborate, I was editing several 2 hour clips and decided to split them into 30mins each to make it easier to navigate

after splitting them I edited them quiet a bit, lots of little trims here and there, only to realize much later the videos were only being render out for about 6~42 seconds and only the water mark

now I've got 11 of these broken renders :( really wished I would of noticed it sooner, though it never crossed my mind to check the files since I did the same thing yesterday in v2.0 with no problems at all

I've gotta re-trim that 10 and a half hours again now :|

User avatar
Bandicam Company
Site Admin
Posts: 7802
Joined: Mon Dec 20, 2010 12:19 pm

Re: bandicut only outputs watemark on already trimmed files

Wed Nov 11, 2015 6:02 pm

Hi mugi,

We could reproduce the problem you mentioned.

We will try to fix this issue as soon as possible.

Thank you for letting us know.

Return to “Bandicut - General Discussion”

Who is online

Users browsing this forum: No registered users and 11 guests